Steelcraft Automotive 53050 GRILL GUARD - Manual

INSTALLATION INSTRUCTIONS
GRILLE GUARD
96-98 4RUNNER/98-00 TACOMA
PARTS LIST
1 – Front Bar
6 – 7/16” x 1-1/4” Hex bolts
2 – Frame brackets 6 – 7/16” Hex nuts
12 – 7/16” Flat washers
INSTALLATION OF BOTTOM FRAME BRACKET
Remove tow hooks from front of vehicle.
Using the bolts that held the tow hooks in place (two bolts per hook) attach the mounting
bracket as per the diagram below. Do not fasten bolts too tightly to allow you to adjust the
alignment.
INSTALLATION OF FRONT BAR
Line up the three holes on the lower portion of the front bar with the three holes on the
frame mounting brackets (outer edge). Using the 7/16” Hex bolts, nuts and washers, fasten
the front bar to the mounting brackets, leaving loose for adjustment.
Once the front bar is attached to the mounting brackets, align until satisfied with fit and
balance, and tighten all fasteners.
NOTE: It is advisable to re-check all fasteners for tightness after one week.