Steelcraft Automotive 53310 GRILL GUARD - Manual

GRILLE GUARD
07-12 TOYOTA TUNDRA / 08-12 SEQUOIA
Page 1 of 5 5/3/12 Rev E (DP)
PARTS LIST:
1 Grille Guard 4 3/8" Flat Washers
1 Driver/Left Frame Mounting Bracket 2 3/8" Nylon Lock Nuts
1 Passenger/Right Frame Mounting Bracket 4 12mm Plastic Washers
1 Driver/Left Top Top Mounting Bracket 4 12-1.75mm x 35mm Hex Bolts
1 Passenger/Right Top Mounting Bracket 4 12mm Lock Washers
1 Driver/Left Top Bracket 4 12mm ID x 32mm OD x 3mm Flat Washers
1 Passenger/Right Top Bracket 4 10-1.50mm x 35mm Hex Bolts
2 10mm Double Bolt Plates 4 10mm Lock Washers
2 3/8" Quick Release Bolts 8 10mm ID x 27mm OD x 3mm Flat Washers
4 3/8" Plastic Washers 4 10mm Nylon Lock Nuts
2 600mm x 50mm x 1.0mm Adhesive Foam Strips
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. NOT
RECOMMENDED FOR VEHICLES WITH OPTIONAL "ACTIVE" LASER GUIDED CRUISE
CONTROL SYSTEMS.
2. WARNING! This Grille Guard is designed to tilt forward by releasing the Quick Release
Bolts on the Top Brackets and loosening the upper bolt on the Mounting Bracket when
the hood needs to be opened for service. Make sure that all hardware is fully tightened
after closing the hood. Read Page 5, "Opening and Closing of Hood," before installing
the Grille Guard.
3. Starting from under the front of the vehicle, remove the (2) factory tow hooks and set aside,
(Figure 1A & 1B).
4. Select the driver/left and passenger/right Frame Mounting Brackets. Refer to the illustration on
Page 1 to identify the Frame Mounting Brackets.
5. Hang the driver/left side Frame Mounting Bracket in position by partially threading the two
factory bolts through the Mounting Bracket and into the frame. NOTE: Depending on model
and year, the vehicle may be equipped with small, (Figure 1A), or large, (Figure 1B), tow
hooks. Only the small tow hook will clear the Frame Mounting Bracket. If desired, install the
small tow hook over the Mounting Bracket using the factory hardware, (Figure 1A). Repeat
this step for the passenger/right side Frame Mounting Bracket installation.
(2) 10mm Double
Bolt Plates
Driver/Left Side Top
Mounting Bracket Passenger/Right Side Top
Mounting Bracket
Driver/Left side Frame
Mounting Bracket Passenger/Right side Frame
Mounting Bracket
Installation Complete
3/8 Quick Release Bolts with
(2) 3/8 Flat Washers
(1) 3/8 Nylon Lock Nut
Passenger/Right
Side Top Bracket Driver/Left Side
Top Bracket