beautypg.com

Steelcraft Automotive 52150 GRILL GUARD User Manual

Installation instructions

background image

Page 1 of 4

6/15/09 Rev3(DP)



PARTS LIST:

Qty Description

Qty

Description

1

Grille Guard

8

10-1.5mm x 45mm Hex Bolts (Gr 8.8)

1

Driver/Left Frame Mounting Bracket

2

10-1.5mm x 35mm Hex Bolts

1

Passenger/Right Frame Mounting Bracket

8

10mm x 30mm OD x 2.5mm Flat Washers

1

Driver/Left Top Mounting Bracket

4

10mm x 20mm OD x 2mm Flat Washers

1

Passenger/Right Top Mounting Bracket

10

10mm Nylon Lock Nuts

1

Driver/Left Frame Top Support Bracket

1

5mm Wrench

1

Passenger/Right Top Support Bracket

2

8mm x 25mm Button Head Allen Bolts

6

12-1.75mm x 35mm Hex Bolts

4

8mm x 16mm OD x 1.6mm Flat Washers

12

12mm x 24mm OD x 2.5mm Flat Washers

2

8mm Nylon Lock Nuts

6

12-1.75mm Nylon Lock Nuts













PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. CUTTING MAY BE
REQUIRED. ASSISTANCE IS RECOMMENDED.

2. Starting on the passenger side, remove the (4) factory hex bolts securing the tow hook to the

frame, (Figure 1 & 2). Place the hardware and tow hook aside. Insert the driver side Frame
Mounting Bracket through the opening in the bumper and up to the mounting surface, (Figure 3).
Secure the Frame Mounting Bracket to the tow hook location using the factory hardware.
IMPORTANT: The Frame Mounting Brackets are supplied with slots for easy adjustment. Use the
supplied (8) 10mm x 30mm OD x 2.5mm Flat Washers between the Hex Bolt and the Frame
Mounting Bracket.

NOTE: If you choose to re-install the tow hooks, use the supplied longer (8) 10mm x 45mm
hex bolts, (8) 10mm x 30mm Flat Washers, factory flat washers and (8) 10mm Nylon Lock
Nuts, (Figure 8). Snug but do not tighten hardware at this time.

3. Cover the top of the bumper cover with a layer of masking tape to prevent damage to the cover

during bracket installation. Loosen the factory (2) hex bolts located on the bottom of the
crossmember, (Figure 4A & 4B). Select the passenger side Top Mounting Bracket and attach it to
the crossmember using the factory hex bolts. Push the bracket back against the crossmember
and tighten the (2) hex bolts on this bracket only, (Figure 5).

INSTALLATION INSTRUCTIONS

GRILLE GUARD

06-09 DODGE RAM 2500-3500



Driver side Top
Mounting Bracket

Driver side Frame
Mounting Bracket

Passenger side Frame
Mounting Bracket

Passenger side Top
Mounting Bracket

Passenger
side Top
Support
Bracket

Driver side
Top Support
Bracket