Steelcraft Automotive 54010 GRILL GUARD - Manual

GRILLE GUARD
2000-2001 NISSAN XTERRA
1998-2000 NISSAN FRONTIER
Page 1 of 2 2/26/10 Rev1(DP)
PARTS LIST:
1 Grille Guard 4 10mm ID x 20mm OD x 2mm Flat Washers
2 Frame Mounting Brackets 6 10mm Lock Washers
1 Driver/Left Top Bracket 6 10mm Hex Nuts
1 Passenger/Right Top Bracket 2 10mm Nylon Lock Nuts
6 10-1.5mm x 35mm Hex Bolts 4 8-1.25mm x 35mm Hex Bolts
2 10-1.50mm x 30mm Button Head Bolts 4 8mm Lock Washers
12 10mm ID x 27mm OD x 3mm Flat Washers 4 8mm x 24mm OD x 2mm Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. From the under the driver side-front of the vehicle, remove the two factory hex bolts inserted
through the front of the frame, (Figure 1). Select a Frame Mounting Bracket and line up the
two top mounting holes with the two holes in the frame. Insert the factory hex bolts back
through the Frame Mounting Bracket and frame. Secure with the factory washer and hex nut.
Repeat this step for the passenger side Frame Mounting Bracket installation. Do not tighten
hardware at this time.
3. With the hood open, locate and remove the two factory 8mm hex bolts located on the driver
side-top of the frame/bumper bracket, (Figure 2). Select the driver side Top Mounting Bracket
and insert it through the opening in the bumper. Line up the two holes in the Mounting Bracket
with the mounting location and secure with (2) 8mm x 35mm Hex Bolts, (2) 8mm Lock
Washers and (2) 8mm Flat Washers, (Figure 2). Snug but do not tighten hardware at this time.
Repeat this step to install the passenger side Top mounting Bracket.
4. With assistance, position the Grille Guard up to the Mounting Brackets. Use the included (6)
10mm x 35mm Hex Bolts, (6) 10mm Lock Washers, (12) 10mm x 27mm OD large Flat
Washers and (6) 10mm Hex Nuts to attach the Grille Guard to the Mounting Brackets, (Figure
3). Snug but do not tighten hardware at this time.
5. Push the Grille Guard into position and attach it to the Top Brackets using (2) 10mm x 30mm
Button Head Bolts, (4) 10mm x 20mm OD small Flat Washers and (2) 10mm Nylon Lock Nuts,
(Figure 4).
6. Level and adjust the Grille Guard properly and tighten all hardware.
Passenger Side Top
Mounting Bracket
Driver Side Top
Mounting Bracket
2) Frame Mounting Brackets
Complete Installation