beautypg.com

Steelcraft Automotive 51320 GRILL GUARD User Manual

Installation instructions

background image

PARTS LIST:

1 Grille Guard

2 10mm Nylock Nuts

2 Mounting Brackets (A)

4 10mm ID x 26mm OD x 3mm Flat Washers

1 Driver Side Top Bracket (C)

4 12-1.75mm x 30mm Hex Head Bolts

1 Passenger Side Top Bracket (B)

4 12mm Nylock Nuts

2 10-1.50mm x 25mm Button Head Bolts

8 12mm ID x 30mm OD x 3mm Flat Washers

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. From front of vehicle remove the passenger side bumper mount bolts. WARNING! Do not

remove passenger and driver bumper mount bolts at the same time. Remove one side at
a time.

3. Place Mounting Bracket onto vehicle and line it up against the gusset bend on the frame.

Leave about 1/8” clearance between bottom of Mounting Bracket and bumper. Secure
Mounting Bracket to vehicle using the factory bolts (Figure 1). Tighten these bolts at this
time.

4. Once the passenger side Mounting Bracket is fully tightened, repeat steps 2 & 3 for driver

side Mounting Bracket. Tighten driver side Mounting Bracket before going to the next
step.

5. Open the hood and determine the Top Bracket mounting location. Remove the passenger

side inner factory bolt located by the latch released. Place Top Bracket and attach it to
vehicle using the factory bolt (Figure 2). Do not tighten at this time.

6. Repeat step 5 for driver side Top Bracket installation.
7. With help position Grille Guard on the outer side of Mounting Brackets. Attach Grille

Guard to Mounting Brackets using the included (4) 12- 1.75mm x 30mm Hex Head Bolts,
(4) 12mm Nylock Nuts, and (8) 12mm Thick Flat Washers (Figure 3). Do not tighten at this
time.

8. Attach Grille Guard to Top Brackets using the included (2) 10-1.50mm x 25mm Button

Head Bolts, (2) 10mm Nylock Nuts, and (2) 10mm Flat Washers (Figure 4). Do not tighten
at this time.

9. Level and adjust Grille Guard as desired, then tighten all hardware at this time.
10.Do periodic inspections to the installation to make sure that all hardware is secure and

tight..

Page 1 of 3

2/22/07

(AM)

INSTALLATION INSTRUCTIONS

GRILLE GUARD

08 FORD SUPER DUTY F250/F350

PART NUMBER

(A)

(A)

(B)

(C)