Steelcraft Automotive 51130 GRILL GUARD - Manual

Installation Instructions
Front Bar Part #
01-04 FORD ESCAPE
Parts List
1 – Front bar
2 – 3/8 x 1” Button Bolts
2 – Frame mounting brackets
4 – 3/8 Hex nuts
2 – top mounting brackets
4 – 3/8 flat washers
4 – ½ flat washers
2 – 3/8 x 1” Hex Special Bolts
8 – 7/16 x 1 ¼ Hex bolts
2 – 5/16 x ¾” Hex bolts
8 – 7/16 Hex nuts
2 – 5/16 Hex nuts
2 –5/16 Flat washers
16 – 7/16 Flat washers
2- M14 Flat washers
Installing the frame mounting brackets
1. Remove the bolts securing the two piece plastic guard located underneath the
vehicle in order to install the frame brackets.
2. Once the plastic guard is removed, kit will show three holes, three on each end of
the member frame.
3. Attach passenger side. (as shown on diagram) Place the mounting frame bracket
flat side up against frame. Slide the bracket until it stops against the tie-down
bracket of the vehicle. (note: you will need to cut off a piece of the front
spoiler bumper, underneath the vehicle where the welded tab of the
mounting bracket sits on) Fasten (do not tighten) the angle end of the bracket to
the vehicle tie-down bracket using the 7/16 x 1 ¼ hex bolts, 7/16 flat washers and
½ flat washers.
4. Insert the 3/8 1” special bolt through the hole on the member frame and mounting
frame bracket. Fasten using the 3/8 hex nuts and 3/8 flat washers.
5. With the help of another person, align the front bar to the mounting frame
brackets (inner side of the mounting brackets) and fasten using the 7/16 x 1 ¼”
hex bolts, 7/16 hex nuts and 7/16 flat washers.
Installing the support brackets
6. Once the front bar is in place, proceed to install the support brackets (refer to the
diagram to identify passenger side). Aligning brackets on the inner side of the