AT&T CL83201 - Manual (Page 51)

Multiple handset use
45
Push-to-talk (PTT)
�TT call to a single device
Using a cordless handset:
1. There are a few ways to begin a PTT call to a single device.
When the handset is not in use:
If you have one handset, press and hold �U�H TO TAL�.
If you have more than one handset:
w Press �U�H TO TAL� on the handset. Then use the
dialing keys to enter the destination device number.
-OR-
w Press �U�H TO TAL� on the handset. Press q
CID
or
p
DIR
to highlight the destination device number. Then
press
MENU
/�ELECT or �U�H TO TAL�.
The handset shows Connecting to HAND�ET X...
( HAND�ET represents the handset name, X represents the
destination handset number) or Connecting to BA�E 0...
( BA�E represents the base name) for a few seconds. When
the connection is made, both your and the destination
device screens display
�ress and hold [�TT] to talk.
2. Press and hold �U�H TO TAL�. A chirp indicates your
microphone is on. Speak towards the device. Your voice is
broadcast to the destination device.
While you are speaking, your handset shows
�TT To handset: X or �TT To base.
3. Release �U�H TO TAL� after speaking. Both devices beep once again and
the screens show �ress and hold [�TT] to talk. Then you can
press and hold �U�H TO TAL� to continue speaking or the destination
device can respond (see Answer a �TT call on page 48).
4. To end the PTT call, press OFF/
CANCEL
or place the handset in the
telephone base or charger. The handset shows �ush to talk Ended for a
few seconds.
•
•
PTT To
handset: X
PUSH TO TALK
>Handset X
p
q
Connecting to
Handset X...
p
q
Press and hold
[PTT] to talk