KB Electronics KBRG-212D User Manual
Page 31
31
Troubleshooting (Continued)
Motor is overloaded. Check motor amps with
DC ammeter in series with armature. (If motor
is shunt type, field may be open or not
receiving proper voltage.)
Check motor for shorts or grounds. Motor
may be defective.
Check position of RCL and FCL trimpots. The
trimpots may be set too low.
OL LED indicator is illuminated.
Rapid Acceleration change will cause the
LED to illuminate. Verify potentiometer
setting.
Note: For any other problems, consult the factory representative.
See also other documents in the category KB Electronics Software:
- KBVF-13 (45 pages)
- KBVF-27 (29 pages)
- KBDF-13 (73 pages)
- KBMA-24D (25 pages)
- KBWA-22D (36 pages)
- KBMK-24D (53 pages)
- KBDA-24D (57 pages)
- KBDA-29 (1P) (57 pages)
- KBDA-24P (57 pages)
- KBAC-24D (28 pages)
- KBAC-29 (1P) (29 pages)
- SIVFR (28 pages)
- DBM Dynamic Braking Module for Single Phase Input Models (4 pages)
- Power On/Off Switch Kit (2 pages)
- IODA, Input/Output Module for use with all KBDA/KBMK Controls (44 pages)
- SIAC, Signal Isolator, installs inside all KBAC Controls (6 pages)
- KBAC/KBDA -24D Power On/Off Switch Kit (1 page)
- KBAC/KBDA-27D Power On/Off Switch Kit (1 page)
- RFAC-24D CE Approved AC Line Filter, installs inside KBAC/KBDA-24D(Class A) (1 page)
- Fittings (KBAC/KBDA Liquid Tight Fittings, 3 x 0.5, 1 x 0.75")" (1 page)
- KBRF-200A CE Approved AC Line Filter for SCR Controls (Class A) (4 pages)
- KBRF-300 CE Approved AC Line Filter (Class B) (8 pages)
- KBTC-125 (1 page)
- KBIC-120 (28 pages)
- KBMM-125 (32 pages)
- KBWD-15 (9 pages)
- KBWS-12 (25 pages)
- KBCC-240D (22 pages)
- KBWT-16 (7 pages)
- KBMG-212D (36 pages)
- KBRG-255 (18 pages)
- KBWM-120 (16 pages)
- KBPC-225D (19 pages)
- KBPI-240D (24 pages)
- KBPW-240D (19 pages)
- KBRC-240D (24 pages)
- KBBC-24M (5 pages)
- Multi Speed Board (16 pages)
- Anti Plug Reversing Module (APRM-PC) w/Switch Kit (for Model 240D Only) (14 pages)
- KBSI-240D KBSI Signal Isolator (16 pages)