AMX Modero ViewPoint MVP-8400 - Manual (Page 78)

Setup Pages
64 MVP Modero ViewPoint Touch Panels
FIG. 55 Wireless Security: Simple Mode
Wireless Security: Simple Mode
Security Type: This field may be switched between WEP, WPA-PSK, and Open. If WEP is
selected, the button to the right may be switched between 64 and 128.
• WEP security requires that both a target WAP be identified and an encryption
method be implemented prior to establishing communication. (Refer to the
WEP Settings section on page 67 for further details.)
• WPA-PSK security is designed for environments where is it desirable to use
WPA or WPA2, but an 802.1x authentication server is not available. PSK
connections are more secure than WEP and are simpler to configure since
they implement dynamic keys but share a key between the WAP and the
panel (client). (Refer to the WPA-PSK Settings section on page 69 for further
details.)
• Open security does not utilize any encryption methodology, but requires an
SSID (alpha-numeric) entry. This entry must match the Network Name (SSID)
entry of the target WAP so the panel knows what device it is using to
communicate with the network. (Refer to the following Open Settings section
on page 67 for further details.)
SSID: Press this field to enter a 32-character Network Name in the Network Name
keypad.
Password: This field is only enabled when WPA-PSK is selected as the Security Type.
Clicking this field opens the Password/Pass Phrase keyboard
WEP Keys: These buttons are only enabled when WEP is selected as the Security Type.
Press each one to open a keyboard to enter a 10-digit WEP Key.
Default Key: This field is only enabled when WEP is selected as the Security Type. Press the
field to select which of the four WEP Keys is the default.
Current Key: This field is only populated when WEP is selected as the Security Type.
Authentication: This field is only enabled when WEP is selected as the Security Type. Press the
field to select between Shared and Open.
Cancel/Save: Press Cancel to return to the Wireless Settings page without saving any
changes. Press Save to save all changes and return to the Wireless Settings
page.