Sonnet Technologies Tempo Trio PCI Adapter Combo Card (Windows) - Manual (Page 6)

Quick Start Guide for Tempo Trio (Windows Version)
6
Windows 2000 Driver Installation
This section describes the installation of drivers to support the Tempo Trio in
systems running Windows 2000. If your system is running Windows 98SE, go
back to page 3. If your system is running Windows Me, go back to page 5. If your
system is running Windows XP, skip to page 7.
1. Turn on your computer; during Windows startup, several New Hardware
Found windows will appear.
2. When the Found New Hardware Wizard window appears, click Next.
3. When the Install Hardware Device Drivers window appears, select “Search for a
suitable driver for my device (recommended),” and then click Next.
4. When the Locate Driver Files window appears, insert the Tempo Trio
Windows Drivers diskette into your floppy drive, and then click Next.
5. When the Driver Files Search Results window appears, select “Install on of the
other drivers,” and then click Next.
6. From the list that appears, select “Win2000 Promise Ultra133...,” and then
click Next.
7. When the Digital Signature Not Found window appears, click Yes; the Mass
Storage Controller driver will be installed.
8. When the Completing the Found New Hardware Wizard window appears,
click Finish; the window will close, several New Hardware Found windows will
appear, and additional drivers will be installed.
9. Eject the Tempo Trio Windows Drivers diskette from your floppy drive, and
then restart your computer to complete the installation. You must now for-
mat any attached hard drives. Skip to “Drive Formatting—Windows 2000”
on page 12.
Support Note: Depending on your system’s configuration before you
install the Tempo Trio (for example, you’ve previously installed a USB
card), some of the drivers required to support the Tempo Trio card may have
already been installed. If this is the case, you may not need to perform some of
the steps listed.