beautypg.com

Quick start guide for tempo trio (windows version) – Sonnet Technologies Tempo Trio PCI Adapter Combo Card (Windows) User Manual

Page 5

background image

Quick Start Guide for Tempo Trio (Windows Version)

5

Windows Me Driver Installation

This section describes the installation of drivers to support the Tempo Trio in
systems running Windows Me. If your system is running Windows 98SE, go back
to page 3. If your system is running Windows 2000, skip to page 6. If your system
is running Windows XP, skip to page 7.

1. Turn on your computer; during Windows startup, an Updating Hardware Info

window will appear.

2. When the Add New Hardware Wizard (PCI Standard PCI-to-PCI Bridge) win-

dow appears, click Next.

3. When the next window appears, select “Automatic Search for a better driver

(Recommended),” and then click Next.

4. When the next window appears, click Finish; the window will close, and

then another New Hardware Found window will briefly appear.

5. When the next Add New Hardware Wizard (PCI OHCI Compliant IEEE 1394

Host Controller, or PCI Mass Storage Controller) window appears, click Next.

6. When the next window appears, select “Automatic Search for a better driver

(Recommended),” and then click Next.

7. When the next window appears, click Finish; the window will close, and

then New Hardware Found windows will appear.

8. When the Add New Hardware Wizard (Win9x-Me Promise Ultra133 (tm) IDE

Controller) window appears, click Next.

9. When the next window appears, select “Specify the location of the driver

(Advanced),” and then click Next.

10. Insert the Tempo Trio Windows Drivers diskette into your floppy drive, and

then click Next.

11. When the message stating “Windows has found multiple software pack-

ages…” appears, click Next.

12. When the message stating “Windows is now ready to install the best

driver…” appears, click Next.

13. When the message stating “Windows has finished installing the software

that your new device requires,” appears, click Finish; the window will close.

14. At the next prompt, eject the Tempo Trio Windows Drivers diskette from

your floppy drive, and then click Yes to restart your system; you must now
format any attached hard drives. Skip to “Drive Formatting—Windows 98SE
and Windows Me” on page 10.

Support Note:

Depending on your system’s configuration before you

install the Tempo Trio (for example, you’ve previously installed a USB

card), some of the drivers required to support the Tempo Trio card may have
already been installed. If this is the case, you may not need to perform some of
the steps listed.