KANOMAX 3887 Handheld Particle Counter - Manual (Page 35)

28
6-1 Alarm
The procedure for setting the alarm is shown below.
Power Up
1.MEASURE MODE
2.DATA PROCESSING
3.OPTIONS
< OPTION >
1. ALARM 4. HOTKEY
2. UNITS 5. AUTOST.
3. UTILITIES
Press ENTER key
1. 0.3um 1.00E+5
2. 0.5um 1.00E+4
3. 5.0um 1.00E+3
< OPTION >
1. ALARM 4. HOTKEY
2. UNITS 5. AUTOST.
3. UTILITIES
Alarm level can be set for each particle size as a
cleanliness criterion. When the set alarm level is
crossed, the reading will flash during a
measurement. Then, you will hear two beeps after
the measurement is complete.
The alarm level setting can only be made for
the “CNT” unit.
Press ENTER key
Press ENTER key