beautypg.com
6
4-1 REPEAT Mode
Setup procedure is shown below. (Character positions may not correspond to the actual screen.)
Power Up
1.MEASURE MODE 2.DATA PROCESSING 3.OPTIONS
< MEASURE MODE >
1.REPEAT 4.CALC 2.SINGLE 5.REMOTE 3.CONT 6.ISO>4
Press ENTER key
REPEAT 0.3/0.5/5.0um LOC.021 STR:N BEEP:N SAMPLE 01:00 2TIMES INT 00:10:00 NO
Measurement Setting Screen
LOC.:
LOC number can be used for identifying room numbers or measurements. Setting of this item is not mandatory.
STR:
Used when storing data in the instrument. When storing the data, select “Y” by using the ▲▼ key. Select “N” if you do not want to store the data.
BEEP:
Alarm goes off when alarm level is exceeded.
SAMPLE:
Sets sampling time. Setting range is from 10 sec to 99min 59sec.
TIMES:
Sets number of sampling times. Setting range is from 1 to 99, or CONT (Repeats until storage capacity is reached. Max. 10,000 times.)
INT:
Sets duration of one measurement cycle. Setting range is from 10sec to 99min 59sec. Minimum time is dependent on set sampling time.
Setting of every item is not mandatory. For example, you can change only the LOC number and press the START/STOP key, and the display will switch to a measurement standby screen.
SAMPLING SAMPLE TIME 00:01:00 TOTAL TIME 00:12:00 OK
REPEAT 30B 20:32 WAIT 0.3 0.00E+0/m3
0.5 0.00E+0/m3
00/02 5.0 0.00E+0/m3
