3 cont mode – KANOMAX 3887 Handheld Particle Counter User Manual

Page 19

4-3 CONT Mode

Setup procedure is shown below.
(Character positions may not correspond to the actual screen.)

Power Up

1.MEASURE MODE
2.DATA PROCESSING
3.OPTIONS

< MEASURE MODE >

1.REPEAT 4.CALC
2.SINGLE 5.REMOTE
3.CONT 6.ISO>4

CONT 0.3/0.5/5.0um
LOC.021 STR:N BEEP:N

FREE REC. 09999 OK

CONT 30B 20:32
WAIT 0.3 0.00E+0/m3
0.5 0.00E+0/m3
5.0 0.00E+0/M3

CONT 30B 20:32
READY 0.3 0.00E+0/m3
0.5 0.00E+0/m3
5.0 0.00E+0/M3

Move the
cursor by
▲▼key.

Press ENTER key

Move the
cursor by
▲▼key.

Measurement Setting Screen

LOC.:

LOC number can be used for identifying room
numbers or measurements. Setting of this item
is not mandatory.

STR:

Used when storing data in the instrument. When
storing the data, select “Y” by using the ▲▼
key. Select “N” if you do not want to store the
data.

BEEP:

Alarm goes off when alarm level is exceeded.

SAMPLE:

Sets sampling time. Setting range is from 10 sec
to 99min 59 sec.

FREE REC.:

Indicates remaining data storage capacity.

Setting of every item is not mandatory.
For example, you can change only the LOC
number and press the START/STOP key, and the
display will switch to a measurement standby
screen.