Ronan X11CA Hardware Manual - Manual (Page 21)

Rev 1.0 Series X11CA Hardware Manual
2. X11CA Hardware Setup
Hardware Control-© 2002 Ronan Engineering 17
Figure 2-13 The Front View Of The Cabinet
After Positioning In The Panel
2. Insert the clamp part A into the groove of the clamp part B as shown in the
figure below.
Figure 2-14 Assembling The Clamp Parts
3. Place the first clamp into the center of the groove behind the extruded trim
of the cabinet and then slide it into about one third from the top left corner
of the cabinet.
Figure 2-15 Inserting the Clamp into the Top Center of the Cabinet Groove.