Robertshaw 9610 - Manual (Page 8)

3. Press PROG/MAN button
until indicator is in PROG position.
Temporary Program Override
To temporarily increase or decrease temperature
Press c or d
The Thermostat will automatically return
to the program at the next scheduled
setting change.
Manual Operation
1. Press PROG/MAN until indicator is in MAN position.
2. Press c or d to adjust
temperature settings.
Reset
To Reset the thermostat to factory pre-programmed
conditions, press the reset button located directly
above the wiring terminal block.
8
ET PROG/MAN
PROG
MAN
PROG
MAN
SET PROG/MAN COOL-OFF-HEAT AUTO - ON > >
NOTE: W
HILE IN THE C OOL MODE , ( OR HEAT AND COOL FOR SINGLE STAGE HEAT PUMP SYSTEM ) ONCE THE THERMOSTAT
TURNS THE SYSTEM OFF , A BUILT - IN DELAY KEEPS THE COMPRESSOR FROM TURNING ON FOR ABOUT 5 MINUTES . T HIS PRO -
TECTS THE COMPRESSOR . N O ADDITIONAL TIME DELAY RELAY ( DELAY ON BREAK ) IS NECESSARY . T OP OVERRIDE THE 5- MINUTE
DELAY FOR INSTALLATION , PRESS RESET. T HIS WILL ERASE THE DELAY AND CHANGE PROGRAMMING TO FACTORY PRE - SETS ..
PROG
MAN
SET PROG/MAN COOL-OFF-HEAT AUTO - ON > >
>
>
> >
PROG
MAN
SET PROG/MAN COOL-OFF-HEAT AUTO - ON
T PROG/MAN PROG
MAN
>
>
RESET
Clears all memory
110-655B.qxd 11/27/06 4:38 PM Page 8