Ransburg Evolver MicroPak Controller A10406 - Manual (Page 22)

OPERATING CONTROLS
(See Figures 2 & 8)
AC Power ON/OFF Switch
(Figure 2)
Turns AC Power to the Evolver MicroPak Con-
troller on or off.
MicroPak ON/OFF Switch
Turns 24VDC power to the MicroPak control unit
on or off.
MicroPak Power Indicator
Glows yellow when the MicroPak ON/OFF switch
is in the ON position.
μA Adjust Knob
Used to adjust the over-current setpoint in com-
bination with the View/Change Setpoint switch
when in local mode.
kV Adjust Knob
Used to adjust the kV setpoint when in local mode.
Kilovolt Meter Display
Displays voltage in thousands of volts (kilovolts)
present at the applicator electrode.
High Voltage Ready Indicator
Glows yellow when High Voltage Ready to the
MicroPak is enabled.
High Voltage ON Indicator
Glows red when high voltage to the applicator is
enabled.
High Voltage Enable/Fault Reset
Switch
Enables high voltage to the applicator when mo-
mentarily moved to the ON position in local mode
with dipswitch SW3-3 off. If dipswitch SW3-3 is
ON high voltage enable is from the remote High
Voltage ON input instead. Also, resets faults when
momentarily moved to the OFF position.
CPU Indicator
Glows green whenever power is supplied to the
Discrete I/O Module.
Active Indicator
Glows green whenever the Discrete I/O Module
is communicating with the MicroPak Control Unit.
Over-Current Fault Indicator
Glows yellow whenever the current from the ap-
plicator exceeds the over-current setpoint.
View/Change Setpoint Switch
Displays present current and voltage setpoints
when held in for 1 to 2 seconds. These settings can
be adjusted while the switch is held in as follows:
When in local mode the kV setpoint is adjusted
using the kV adjust knob. When in remote mode
the kV setpoint is adjusted by changing the remote
0 to 10VDC kV setpoint input. When in local mode,
the over-current setpoint is adjusted by using the
uA Adjust Knob. When in remote mode the over
† This switch is located on the rear of the
controller.
NOTE
† In local mode, with dipswitch SW3-3
OFF, the HV Ready Indicator will not light
until the high voltage is enabled.
NOTE
OPERATION
Evolver MicroPak Controller - Operation
Ransburg
19 LN-9622-00.5