Mma-303 direct/indirect charge - introduction, Specifications - electrical / mechanical – Ransburg MMA-303 Direct_Ind Charge Atomizer A12870 User Manual

Page 13

MMA-303 Direct/Indirect Charge - Introduction

LN-9269-11.3

SPECIFICATIONS - Electrical / Mechanical

Electrical

Power Supply Type:

MicroPak

Charging Method:

Direct and Indirect

Output Voltage:

100 kV Maximum - Direct

// 30-70 kV Variable - Indirect

Output Current:

1000 µA

Turbine Speed Control:

Atomizer Module

Part Spray ability:

Determine spray ability of part to be coated using Test Equip-

ment (76652) (Paint Conductivity Meter)

Mechanical

Length:

(See “MMA-303 Tool Center Point Dimension” figures in the

“Introduction” section.)

Diameter:

(See “MMA-303 Tool Center Point Dimension” figures in the

“Introduction” section.)

Approximate Weight:

(See “MMA-303 Tool Point Dimension” figures in the

“Introduction” section.)

Turbine Type:

Air Bearing Impulse Drive

Turbine Air Supply:

Variable (See “Pressure Flow Data Charts” in the

“Introduction” section.)

Maximum/Minimum
Turbine Speed:

Continuous 70K rpm max./20K rpm min.

Maximum Angular Velocity
for Turbine (Robot Motion):

250˚/sec.

Bearing Air Supply
at the Applicator:

90 psig (±10 psi)

(Nominal):

621 kPa ± 69 kPa)

2.9 SCFM (82 slpm)

Shaping Air #1 (SAI) Supply:

Variable (See “Pressure Flow Data Charts” in the

“Introduction” section.)

Shaping Air #2 (SAO) Supply:

Variable (See “Pressure Flow Data Charts” in the

“Introduction” section.)

Brake Air Supply:

60-100 psig

(Nominal):

(414-689 kPa)