Ransburg DynaFlow Programmers Manual - Manual (Page 45)

Command T
ype (hex)
Response Or
Action From User Interface
Response Or
Action From Interface Module
<1A>
Not Used.
Not Used.
<1B>
Not Used.
Not Used.
<1C>
Request tLookup T
able data:
<1C><0G> Where 1) = message length = <02h>. 2) = Gun #. 3) = Job #.
Response: <1C> Where: 1) = message length = <20h>. 2) <0G> = Gun #. 3) = Job #. 4) = Flow Rate for Entry #0. 5) = Output for Entry #0. 6) = Flow Rate for entry #1. 7) = Output for entry #1. 8) = Flow Rate for entry #2. 9) = Output for entry #2. 10) = Flow Rate for entry #3. 1
1) = Output for entry #3.
12) = Flow Rate for entry #4. 13) = Output for entry #4. 14) = Flow Rate for entry #5. 15) = Output for entry #5. 16) = Flow Rate for entry #6. 17) = Output for entry #6. 18) = Flow Rate for entry #7. 19) = Output for entry #7. 20) = Flow Rate for entry #8. 21) = Output for entry #8. 22) = Flow Rate for entry #9. 23) = Output for entry #9.
41
DynaFlow Programer's Manual - Introduction
Ransburg
LN-9406-00.3