Ransburg DynaFlow Programmers Manual - Manual (Page 33)

Command T
ype
(hex)
Response Or
Action From User Interface
Response Or
Action From Interface Module
1
1) = pulses per liter
.
12) = dead band. 13) = proportional gain. 14) = integral gain. 15) = derivative gain. Slave Channel V
ariables:
16) = MVR high value. 17) = MVR low value. 18) = pulses per liter
.
19) = dead band. 20) = porportional gain. 21) = integral gain. 22) = derivative gain. Note:
The data for the slave channel will be included whether or not
the
Gun
is
configured
for
two
channels.
<03>
Request for Gun Process data: <03> Where: 1) = message length=<01h>. 2) = Gun #.
Response: <03> < Where: 1) = message length = <23h>. 2) = # of Channels in the upper nibble and the Gun # in the lower nibble. 3) = Master Channel # in the upper nibble and the Slave Channel # in lower nibble. 4)
=
Gun
mode,
<00>
for
Automatic,
<01>
for
Manual,
<02>
for
undefined.
5) = Clean Channels Enable/Disable
0x00
=
Both
Channels
Enabled
0x0F
=
Master
Channel
Enabled/Slave
Disabled
0xF0
=
Slave
Channel
Enabled/Master
Disabled
0xFF
=
Both
Channels
Disabled
6) = Default Job #. 7) = Reverse Flow
.
8)
=
Mixed
V
olume.
9) = Flow
Tolerance.
10) = Flow
Tolerance
Time.
1
1) =
Tolerance V
olume.
12) =
Trigger Of
f delay
.
13) =
Trigger On delay
.
14) =
Tolerance V
olume
Time (not used)
29
DynaFlow Programer's Manual - Introduction
Ransburg
LN-9406-00.3