Kasco Marine VFX Series - Manual (Page 6)

6
A. Aerator (Unit with cord or unit with Disconnect)
(1)
A1. Cord in separate box (1) (depending on size of
cord)
B. Float in separate box (1) (Diagram to Right)
1. 3 Float Sections (1)
2. Top Float Bracket (3)
3. Bottom Float Bracket w/ 50’ rope (3)
4. 9” x 3/8” Black Coated Bolt (6)
5. 3/8” Lock Nut (6)
6. 1/4” x 1” Bolt (6)
7. 1/4” x 3/4” Bolt (3)
8. 1/4” Lock Washer (12)
9. Bottom Screen (1)
10. Top Screen (1)
11. Top Screen Clip (3)
12. 1/4” Nut (6)
13. Bottom Screen Clip (3)
14. 1/4-20 x 3/4” Brass Screw (3)
15. Mesh screen (1)
16. Cable ties (10)
C-85 Control Panel in separate box (1) for 8400VFX
C-95 Control Panel in separate box (1) for 5.1VFX
NOTE: Extra hardware may be included.
TOOLS & SUPPLIES NEEDED
• Anchors or stakes for installing unit (3)
• Philips head screw driver for mounting C-85
• 240V Electrical Supply near pond on a post with
room for mounting the C-85
• Three 12” long galvanized 1” diameter pipe for
weighting ropes (optional)
• #10 x 1” long or longer screw(s) for mounting the
C-85 (4)
• 7/16” Socket & Wrench (1)
• 7/16” Wrench (1)
• 9/16” Socket & Wrench (1)
• 9/16” Wrench or adjustable crescent wrench (1)
• Flat head screw driver (1)
8400VFX, 2.3(H)VFX, 5.1VFX, 5.3(H)VFX
Assembly
1. Remove all contents from package and place on
a clean, flat surface. Inspect the shipment for any
damages. If damages are found, immediately notify
your carrier and your Kasco Marine, Inc. representa-
tive. Next, cross reference the parts included in the
shipment with the Parts Included section in this man-
10. Turn the assembly upright again. At this time, if
the cord contains a metal strain relief, you can use the
chain connector and attach it in one of the opening at
the rope placement. The chain connector will easily fit
if installed from the bottom or top side of the opening.
It will not fit if installed from side of opening. Use the
Nylon Cable Tie included to secure the power cord to
a molded hole in the float to prevent cord damage if
there is no strain relief on the cord. If a Strain Relief
is present on the cord, you may disregard the Nylon
Tie. On cords with a Quick Disconnect, the discon-
nect should be tightened properly to avoid leaking.
If installing a new Quick Disconnect, refer to Quick
Disconnect Instructions.
8400VFX, 2.3(H)VFX, 5.1VFX, 5.3(H)VFX
Parts
8400VFX, 2.3VFX PARTS INCLUDED
5.1VFX, 5.3VFX PARTS INCLUDED