Kasco Marine VFX Series - Manual (Page 2)

2
THANKS
We at Kasco Marine, Inc. would like to both thank and
congratulate you on your purchase of the VFX model
aerator. We appreciate you choosing Kasco and for
your purchase. Your decision to purchase Kasco’s
VFX model Aerator will not disappoint you. The VFX
model Aerator will be a great addition to your body
of water. It will help improve the water quality by
adding much needed oxygen and circulation. It will
also enhance the aesthetics of the pond or lake with a
beautiful pattern. The lighting package (if purchased)
will illuminate your aerator for beauty at night. We
thank you for choosing Kasco for your aerator needs
and want you to be completely satisfied with your
purchase.
Important Safety Instructions
Please read and follow these extremely important
safety and handling instructions for your Kasco equip-
ment. Following these instructions will help ensure
your safety and the quality performance of your equip-
ment.
• Under NO circumstances should anyone enter the
water with the electrical equipment plugged in
and/or in operation. All Kasco equipment is ETL
approved to UL and CSA standards for safety in
water. However, it is NEVER recommended to
enter the water with the equipment in operation.
• Caution should be used when dealing with any
electrical equipment with moving parts.
• NEVER run the unit out of water. It will damage
the seals and create a dangerous situation for the
operator.
• Extreme caution should be used around water,
especially cold water, such as in Spring, Fall, and
Winter, which poses a hazard in and of itself.
• NEVER lift or drag the aerator by the power or
light cord. If you need to pull the unit to the side
of the pond, use the anchoring ropes.
• Do not use waders in deep ponds/lakes or ponds/
lakes with drop-offs, drastic slopes, or soft bottom
material.
• Do not use boats that tip easily for aerator installa-
tion, such as a canoe, and follow all boating safety
rules and regulations, including wearing a PFD.
(Personal Flotation Device)
• Single phase aerators are supplied with an inter-
nal grounding conductor and/or a grounding-type
attachment plug. To reduce the risk of electrical
shock, be certain the aerator is properly connected
to the Kasco supplied control panel. (refer to the
C-25, C-85 & C-95 Control instructions)
• 3 phase aerators (2.3VFX, 5.3VFX) require a
startup test after wiring to ensure proper rotation of
the propeller. If the propeller is rotating in the op-
posite direction, the unit will not perform properly
and internal damage to the unit may occur. (See 3
phase startup procedure)
• Control panels must be installed a minimum of
5ft(3m in Canada) from the inside wall of the
pond, unless separated from the body of water by
a fence wall, or other permanent barrier that will
make the unit inaccessible to persons in the water.
• Control panels must be installed by a qualified
electrician.
• Ground Fault Circuit Interrupters (GFCI) should
be tested upon each installation and every month
thereafter to ensure proper operation.
General Owner’s Instructions
INSPECT THE SHIPMENT
Immediately inspect your Kasco Aerator shipment for
any visible damages. Also cross reference the parts
supplied with the Parts Included sheet to check for
shortages. Shortages should be reported immediately
to your Kasco Marine distributor or representative and
damages reported to your carrier and Kasco Marine.
CAUTION
WARNING: Under NO circumstances should anyone
enter the water with the unit in operation. Always
operate the unit in the water and keep people and ob-
jects clear of the propeller. Do not lift or pull the unit
by the electrical cord. Always use extreme caution
around electrical equipment and water situations.
ASSEMBLY & INSTALLATION
Please see the proper Assembly and Installation In-
structions enclosed in this manual. Each is specific
for your model and size of aerator. Note: Use a nylon
tie to help keep the power cords for the unit and lights
free of the propeller by tying each cord to either side
of the float. If you have a light kit, make sure that the
unit cord is tied to one side of the float and the light
cord to the other for balance. Note: It is extremely