Hauler Racks Universal Steel Truck/Cap Rack (STC3-1) User Manual
Page 14
Removable rear cross bar option.
The rear crossbar can be removed or pivot out of the way when loading tall upright cargo into the truck bed.
Removal
To remove the rear crossbar - unbolt the crossbar from the leg on both sides.
NOTE: Always have the crossbar secured with all bolts on both ends when using the vehicle.
Pivoting crossbar
Note! This feature should only be used when a load is not carried on the crossbars. If a
load is going to be carried on the crossbars, all four bolts must be used to secure the
crossbar to the legs!
To change the rack for pivoting the rear crossbar, remove the hardware holding the rear crossbar in place.
On the end with the 1-3/4” inner crossbar, use a 4-1/2” bolt with flat washer and slide them through the upper hole of
the leg.
Place a flat washer on the 4-1/2” bolt and move it to so it contacts the leg.
Place the crossbar onto the bolt and slide towards the leg.
Secure the crossbar to the leg using a flat washer and nylon insert lock nut.
Tighten the nut and bolt enough so the crossbar can be rotated around the bolt but not binding.
14 of 16
HAULER RACKS, INC.
7109 31
st
Avenue North
Minneapolis, MN 55427-2848
WWW.HAULERRACKS.COM
Toll Free: 1-800-843-5445
Phone: 763-546-5620
Fax: 763-546-0933