Hauler Racks SERVICE BODY ‘A’ MOUNT RACKS - Manual

ASSEMBLY INSTRUCTIONS FOR
SERVICE BODY ‘A’ MOUNT RACKS
T12 Service Body ‘A’ shown with optional middle crossbar
Package Contents:
HARDWARE KIT
PARTS
(8) 3/8”-16 x 3” CARRAIGE BOLTS (1) RAIL DRIVER’S SIDE ASSEMBLIES
(20) 3/8”-16 x 2” CARRAIGE BOLTS (1) RAIL PASSENGER’S ASSEMBLIES
(4) 3/8”-16 x 1-3/4” CARRAIGE BOLTS (1) FRONT RECTANGLULAR CROSSBAR
(12) 3/8”-16 x 1-3/4” HEX BOLTS (1) MIDDLE CROSSBAR ASSEMBLY WITH ‘H’ & ‘T’ BRACKETS
(4) 3/8”-16 x 1-1/2” HEX BOLTS (1) REAR CROSSBAR WITH ‘T’ BRACKETS
(12) 3/8”-16 x 1-1/4” HEX BOLTS (2) FRONT LEGS
(60) 3/8”-16 NUTS (2) REAR LEGS
(60) 3/8” SPLIT LOCK WASHERS (4) HD BRACES
(4) ‘A’ MOUNT ANGLE BRACKETS
(4) ‘A’ MOUNT FLAT BRACKETS
(2) SERIES 2000 PANELS & HARDWARE (EX RACKS ONLY)
Before you begin:
Remove all components from the shipping carton.
The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands
securing components together.
Read the instructions thoroughly to familiarize yourself with the assembly sequence.
Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for
minor adjustments to the rack during the installation process.
Gather the following tools used to assemble and install the rack.
1/2” & 9/16” Sockets or open end wrenches
5/16” & 3/8” Drill bits and drill
Pencil or marker
Tape measure
Center punch and hammer (optional)
Level (optional)
2 Clamps (optional)
Boards (optional)
HAULER RACKS, INC. Toll Free: 1-800-843-5445
7109 31 st Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
Page 1 of 16 WWW.HAULERRACKS.COM