Hauler Racks SERVICE BODY ‘C’ MOUNT RACKS - Manual

ASSEMBLY INSTRUCTIONS FOR
SERVICE BODY ‘C’ MOUNT RACKS
Service Body ‘C’ shown
HAULER RACKS, INC. Toll Free: 1-800-843-5445
7109 31 st Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
Page 1 of 15 WWW.HAULERRACKS.COM
Package Contents:
HARDWARE KIT
(8) 3/8”-16 x 3” CARRAIGE BOLTS
(20) 3/8”-16 x 2” CARRAIGE BOLTS
(4) 3/8”-16 x 1-3/4” CARRAIGE BOLTS
(4) 3/8”-16 x 1-1/2” HEX BOLTS
(12) 3/8”-16 x 1-1/4” HEX BOLTS
(44) 3/8”-16 NUTS
(44) 3/8” SPLIT LOCK WASHERS
PARTS
(1) RAIL DRIVER’S (LEFT) SIDE ASSEMBLY
(1) RAIL PASSENGER’S (RIGHT) SIDE ASSEMBLY
(1) FRONT RECTANGLULAR CROSSBAR
(1) MIDDLE CROSSBAR ASSEMBLY WITH ‘H’ & ‘T’ BRACKETS
(1) REAR CROSSBAR WITH ‘T’ BRACKETS
(4) LEGS WITH SERVICE BODY ‘C’ FEET
(4) HD BRACES
(2) SERIES 2000 PANELS (EX RACKS ONLY)
Before you begin:
Remove all components from the shipping carton.
The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands
securing components together.
Read the instructions thoroughly to familiarize yourself with the assembly sequence.
Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for
minor adjustments to the rack during the installation process.
Gather the following tools used to assemble and install the rack.
1/2” & 9/16” Sockets or open end wrenches
5/16” & 3/8” Drill bits and drill
Pencil or marker
Tape measure
Center punch and hammer (optional)
Level (optional)
2 Clamps (optional)
Boards (optional)