Hauler Racks ULRHDGC-1 - Manual

ALUMINUM “UNIVERSAL” VAN / CAP RACK
INSTRUCTIONS ROOF MOUNT APPLICATION
P/N ULRHDGV-1 / ULRHDGC-1
Package Contents:
(8) Load Secure Posts
(2) Cross Bars
(4) Curved Arms
(4) G Mount Hinges
(4) G Mount Rubber Gaskets
(4) G Mount Flat Plates
(8) 5/16” x 1” Carriage Bolts
(8) 5/16” Nuts
(8) 5/16” Split Lock Washers
(16) 3/8-16 x 1-3/4” Bolts
(16) 3/8-16 Nuts
(16) 3/8 Split Lock Washers
(12) ¼” Nuts
(12) ¼” Split Lock Washers
(12) ¼” x 1-1/2” Phillips Screws
Before you begin:
Remove all components from the shipping carton.
The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands securing
components together.
Read the instructions thoroughly to familiarize yourself with the assembly sequence.
Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for minor
adjustments to the rack during the installation process.
Gather the following tools used to assemble and install the rack.
7/16”, 1/2” & 9/16” Socket or open end wrench
Phillips screw driver
5/16” dia drill bit and drill
Waterproof Silicon Sealer (optional, not included)
Marker
HAULER RACKS, INC. Page 1 of 6 Toll Free: 1-800-843-5445
7109 31
st Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
WWW.HAULERRACKS.COM