Hauler Racks TRANSIT CONNECT RACK User Manual
Assembly instructions for transit connect rack

ASSEMBLY INSTRUCTIONS FOR
TRANSIT CONNECT RACK
FTC948-1 shown above
HAULER RACKS, INC.
Toll Free: 1-800-843-5445
7109 31
st
Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
Page 1 of 10 WWW.HAULERRACKS.COM
Package Contents:
HARDWARE KIT
PARTS
(4) 3/8”-16 x 3” CARRIAGE BOLTS
(1) RAIL DRIVER’S SIDE ASSEMBLY
(16) 3/8”-16 x 2” CARRIAGE BOLTS
(1) RAIL PASSENGER’S ASSEMBLY
(2) 3/8”-16 x 1-3/4” CARRIAGE BOLTS
(1) FRONT RECTANGLULAR CROSSBAR
(8) 3/8”-16 x 1-3/4” HEX BOLTS
(2) MIDDLE CROSSBAR ASSEMBLIES WITH ‘H’ BRACKETS
(30) 3/8” SPLIT LOCK WASHERS
(1) REAR RECTANGLULAR CROSSBAR
(30)
3/8”-16
NUTS
(4)
G-MOUNT
HINGE
ASSEMBLY
(12) 5/16” SPLIT LOCK WASHERS
(4) CURVED MOUNT ARM
(8) 5/16” HEX NUTS
(8) 5/16” X 1” CARRIAGE BOLTS
(4) RUBBER GASKETS
(4)
M8
x
20MM
HEX
BOLTS
Before you begin:
Remove all components from the shipping carton.
The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands
securing components together.
Read the instructions thoroughly to familiarize yourself with the assembly sequence.
Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for
minor adjustments to the rack during the installation process.
Gather the following tools used to assemble and install the rack.
9/16” Sockets or open end wrenches
1/2” Sockets or open end wrenches
Boards (optional)