Hauler Racks V11SGV-1 - Manual

HAULER RACKS, INC. Toll Free: 1-800-843-5445
7109 31 st Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
Page 1 of 9 WWW.HAULERRACKS.COM
ASSEMBLY INSTRUCTIONS FOR
V10SG and V11SG ‘G’ MOUNT RACKS
P/N V10SGV-1 / V11SGV-1
Before you begin:
Remove all components from the shipping carton.
The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands
securing components together.
Read the instructions thoroughly to familiarize yourself with the assembly sequence.
Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for
minor adjustments to the rack during the installation process.
Gather the following tools used to assemble and install the rack.
9/16” Socket or open end wrench
1/2” Socket or open end wrench
7/16” Socket or open end wrench
Phillips screwdriver
5/16” Drill bit and drill
Pencil or marker
Tape measure
Center punch and hammer (optional)
Package Contents:
HARDWARE KIT
(6) G-MOUNT FLAT PLATES
(6) G-MOUNT RUBBER GASKETS
(8) 3/8”-16 x 3” CARRAIGE BOLTS
(16) 3/8”-16 x 2” CARRAIGE BOLTS
(4) 3/8”-16 x 1-3/4” CARRAIGE BOLTS
(4) 3/8”-16 x 1-1/2” HEX BOLTS
(32) 3/8”-16 NUTS
(32) 3/8” SPLIT LOCK WASHERS
(12) 5/16”-18 x 1” CARRIAGE BOLTS
(12) 5/16”-18 NUTS
(12) 5/16” SPLIT LOCK WASHERS
(18) ¼”-20 X 1-1/2” PHILLPS SCREWS
(18) 1/4” -20 NUTS
(18) ¼” SPLIT LOCK WASHERS
(12) SPACERS
PARTS
(1) RAIL DRIVER’S (LEFT) SIDE ASSEMBLY
(1) RAIL PASSENGER’S (RIGHT) SIDE ASSEMBLY
(1) FRONT RECTANGLULAR CROSSBAR
(1) REAR CROSSBAR
(2) MIDDLE CROSSBAR ASSEMBLIES WITH ‘H’ BRACKETS
(6) CURVED ARMS
(6) G-MOUNT HINGE ASSEMBLIES