Hauler Racks TLRSAA-1 - Manual

ALUMINUM REMOVABLE TRUCK SIDE
LADDER RACK INSTRUCTIONS
P/N TLRSAA-1
Package Contents:
HARDWARE
KIT PARTS
(28) 3/8”-16 NUTS (2) LEGS
(28) 3/8” SPLIT LOCK WASHERS (2) CROSSBARS
(8) 3/8”-16 x 1-1/4” HEX BOLTS (2) “T” BRACKETS
(8) 1” x 3/8” HEX LAG BOLTS (2) LIP MOUNTS
(8) 3/8”-16 x 1” HEX BOLTS (2) BED MOUNTS
(6) 3/8”-16 x 1-1/2” HEX BOLTS (2) HD BRACES
(2) 3/8”-16 x 2” HEX BOLTS (4) LOAD SECURE POSTS
(4) 3/8”-16 x 2” CARRAIGE BOLTS
(2) RECTANGLE END CAPS
Before you begin:
Remove all components from the shipping carton.
The rack should be assembled on a padded surface such as
carpet to prevent scratching of aluminum surfaces. Remove
bands securing components together.
Read the instructions thoroughly to familiarize yourself with the
assembly sequence.
Note that you DO NOT tighten any nuts and bolts until the
completed rack is installed on the vehicle unless specified.
This allows for minor adjustments to the rack during the
installation process.
Gather the following tools used to assemble and install the
rack.
9/16” Socket or open end wrench
3/8” Drill bit and drill
Pencil or marker
Tape measure
Center punch and hammer (optional)
Level (optional)
HAULER RACKS, INC. Page 1 of 6 Toll Free: 1-800-843-5445
7109 31
st Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
WWW.HAULERRACKS.COM
1. “T” bracket assembly.
Insert (2) 3/8”-16 nuts into each of the outer channels of the crossbar.