beautypg.com

Hauler Racks Hauler II Camper Shell Racks User Manual

Hauler Racks For the car

background image

ASSEMBLY INSTRUCTIONS FOR HAULER II

UNIVERSAL CAMPER SERIES RACKS

C11U2873-1 shown above

HAULER RACKS, INC.

Toll Free: 1-800-843-5445

7109 31

st

Avenue North Phone: 763-546-5620

Minneapolis, MN 55427-2848 Fax: 763-546-0933

Page 1 of 14 WWW.HAULERRACKS.COM


Package Contents:

HARDWARE KIT

PARTS

(4) 3/8”-16 x 3” CARRAIGE BOLTS

(1) RAIL DRIVER’S SIDE ASSEMBLY

(20) 3/8”-16 x 2” CARRAIGE BOLTS

(1) RAIL PASSENGER’S ASSEMBLY

(2) 3/8”-16 x 1-3/4” CARRAIGE BOLTS

(1) FRONT RECTANGLULAR CROSSBAR

(12) 3/8”-16 x 1-3/4” HEX BOLTS

(1) MIDDLE CROSSBAR WITH ‘T’ AND ‘H’ BRACKETS ASSEMBLY

(4) 3/8”-16 x 1-1/2” HEX BOLTS

(1) REAR CROSSBAR WITH ‘T’ BRACKETS ASSEMBLY

(4) 3/8”-16 x 1-1/4” HEX BOLTS

(4) LEGS

(4) 3/8” x 1-1/4” LAG BOLTS

(4) CAMPER FEET

(46) 3/8”-16 NUTS

(4) HD BRACES

(46) 3/8” SPLIT LOCK WASHERS

Before you begin:

Remove all components from the shipping carton.

The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands
securing components together.

Read the instructions thoroughly to familiarize yourself with the assembly sequence.

Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for
minor adjustments to the rack during the installation process.

Gather the following tools used to assemble and install the rack.

9/16” Sockets or open end wrenches
3/8” Drill bits and drill
Pencil or marker
Tape measure
Center punch and hammer (optional)
Level (optional)
2 Clamps (optional)
Boards (optional)