Hauler Racks TLRSAA-1 - Manual (Page 5)

HAULER RACKS, INC. Page 5 of 6 Toll Free: 1-800-843-5445
7109 31
st Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
WWW.HAULERRACKS.COM
7. Mounting to truck bed
Place the ladder rack assemblies on the truck in the desired positions.
Adjust the lip mount so that it rests on the lip of the truck bed. Make sure the legs are straight up and down. For best results, use a level to
check plumb.
Using the lip mount and bed mount as templates, mark holes to be drilled.
Check for access underneath marked holes for clearance needed to install washers and nuts. Adjust position if needed. If access is not
available, use the 3/8” x 1” lag bolts. If using the lag bolts, install by drilling ¼” diameter holes.
Use a drill and make (2) 3/8” diameter holes in the lip of the truck bed and (2) holes in the floor of bed at the marked locations.
Mount the lip mount to the lip of the truck bed using 3/8”-16 x1-1/4” hex bolts, 3/8” split lock washers and 3/8”-16 nuts.
Mount the bed mount to the bed floor using 3/8”-16 x1-1/4” hex bolts, 3/8” split lock washers and 3/8”-16 nuts.
Check straightness and then tighten all mounting hardware. Position the adjustable load secure post as needed.