Hauler Racks TLRSAA-1 - Manual (Page 2)

HAULER RACKS, INC. Page 2 of 6 Toll Free: 1-800-843-5445
7109 31
st Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
WWW.HAULERRACKS.COM
1. “T” bracket assembly continued.
Slide the 3/8”-16 nuts in approximated 8-1/4” and 5” from the end of the crossbar.
Orientate the “T” bracket as shown below; note which way the angles point. Position the “T” bracket over the nuts and install using (4) 3/8”-
16 x 1” hex bolts and (4) 3/8” split lock washers. Adjust the “T” bracket so that the edge is 4.5” from the end of the crossbar. Tighten the all
bolts.
2. Load secure post assembly.
Slide (1) 3/8”-16 x 1-1/2” hex head bolt into the center channel of the cross bar on the end closest to the “T” bracket and (2) 3/8”-16 x 1-1/2”
hex head bolts into the center channel of the cross bar on the end furthest from the “T” bracket.