Gentec-EO P-LINK User Manual

Page 29

P-

LINK User’s Manual Revision 15.0

Gentec Electro

*FAS

Turns the autoscale mode on.

“ACK\r\r\n”

Please note that you must type the exact number of characters or numerical values required.

Example: *AOB1.00E+01 has 8 characters/numerical values. Don’t put any space between

characters or numerical values.

7.2

P-LINK Error Messages

“\r\r\nE01\r\r\n” Bad Command

“\r\r\nE02\r\r\n” Energy Mode is not available

“\r\r\nE03\r\r\n“ N/A

“\r\r\nE04\r\r\n“ The selected wavelength correction factor is not valid

“\r\r\nE05\r\r\n” The connector is not connected

“\r\r\nE06\r\r\n” Attenuator not available