Gentec-EO P-LINK - Manual (Page 27)

P- LINK User’s Manual Revision 15.0 27
Gentec Electro – Optics, Inc. All rights reserved
7 Appendix A
7.1 P-LINK Serial commands
The star(*) is part of each command
Commands Description Return Example
*ATT Turns the attenuator correction ON when available for the detector “ACK\r\r\n”
*ATF Turns the attenuator correction OFF. OFF by default. “ACK\r\r\n”
*CAU Sends the data points through the serial port at a frequency of 10
Hz “9.793354e-01\r\r\n
9.792939e-01\r\r\n
”
*CSU Ends the *CAU mode “ACK\r\r\n”
*CVU Returns a single measurement (the current measurement) through
the serial port. “ACK\r\r\n9.793354e-
01\r\r\n ”
*ANT Turns the anticipation ON. ON by default & return caracters
« ACK » “ACK\r\r\n”
*ANF Turns the anticipation OFF “ACK\r\r\n”
*CFT Turns the power correction ON. ON by default. “ACK\r\r\n”
*CFF Turns the power correction OFF “ACK\r\r\n”
*AOB Modifies the analog output voltage value (*AOB + 8 characters)
Example : *AOB1.00E+01 The maximum value of the analog
display (2.05 volts) is 10 watts
“ACK\r\r\n”
*AOD Sets an analog output delay from 1s to 7s for a return to 0V after
an energy measurement. Default 0 (no return to zero after an
energy measurement).
Example : *AOD2.00E+00 The delay is 2 seconds.
“ACK\r\r\n”
*RST Resets the device “”
*SOU Sets the zero offset “ACK\r\r\n”
*KPA Returns the character string « ACK » “ACK\r\r\n”
*PWC Wavelength correction value (+ 5 characters)
Example : *PWC01064 selects the wavelength 1064 nm
“ACK\r\r\n”