Gentec-EO P-LINK User Manual

Page 10

P-

LINK User’s Manual Revision 15.0

Gentec Electro

The P-LINK works with all Gentec-EO power detectors. It automatically recognizes every
power detector head, which ensures accurate auto-calibration. More importantly, it can take
advantage of our Personal wavelength correction

™. It reads the memory in the Smart

Interface connector (version 5 and higher) to provide a wavelength correction that is based on
spectral data measured from that specific detector.

The P-LINK may not recognize some of the earlier heads.

WARNING: This DB-15 connector, though similar to that of the former TPM-310 and TPM-330

monitors, is incompatible with the power detector heads of PS-310 Series Version 1
and PS-330 Series Version 1. These heads used a different technology and do not
have the same pin-out configuration.

The GENTEC C-300 adaptor can be used in order to connect the power detector heads of PS-
310 Series and PS-330 Series Version 1 and 2. Please contact your local Gentec-EO
distributor or the nearest Gentec-EO office for further information.

Any attempt to modify connectors of the early version heads to mate with the P-LINK can
result in damage to the monitor.