General Tools and Instruments GT310 - Manual (Page 17)

15. Plug the dongle into any open USB port on your computer. Doing so
will cause the following screen to appear.
16. On the meter, press the Power/Tx/Rx/Ax button once. The
icon will appear at right. You will next choose CH-1 as the meter’s
transmitting channel. To do so, press and hold the Hold/CH
button. When a flashing “0” (the default channel number) appears
at the right of CH- on the upper readout, quickly (within 10
seconds) press the Select/0-9 button once to advance the channel
counter to “1”. Quickly save the setting by pressing and holding
the Hold/CH button.
17. On the “DMMD_PCView GTSF05” screen, click the Scan CH
button. The program will begin scanning Channels 0 through 9.
Scanning will stop when the GT310’s transmission on Channel 1 is
detected, causing the
ᕃ button to turn green.
18. Click again on the green
ᕃ button to produce a display like the
following:
17