beautypg.com

General Tools and Instruments DCS800 User Manual

Page 9

background image

3. Replace the cover and flip it down until it snaps shut, flush against the

back of the unit (right figure below).

ATTACH HAND STRAP AND PROBE

If you choose to use the included adjustable padded hand strap, you must
install it at the same time as the camera-tipped probe because the probe
secures one end of the strap.

Begin by locating the end of the hand strap with the black plastic bracket and
thumbscrew (see right photo below). Attach this end of the strap to the console
by inserting the thumbscrew into the threaded hole on the bottom edge of the
unit and tightening the screw.

Then turn your attention to the other, free end of the strap. Slip the hole in the
free end over the probe connector on the top edge of the console (left photo
below). Then position the connector of your probe directly above the console’s
probe connector.

9

DCS800-manual_fiNAL-030313_awb 3/1/13 12:37 PM Page 9