General Tools and Instruments DCS800 User Manual
Page 24
• Never use the probe or camera head to modify surroundings or to clear
pathways or clogged areas.
• The camera head, LEDs and thread protector ring are waterproof, but not
acid-proof or fire-proof. Do not touch acidic, corrosive or hot materials or
they will ruin the head.
• Cover the camera-tipped end of the probe with the protective rubber cap
when not using it.
• Unless you wish to install the mirrored viewing tip, do not unscrew the
thread protector ring from the camera head.
• When inspecting a vehicle, shut off the engine. Metal and liquid under the
hood may be hot. Do not get oil or gas on the camera head.
• If condensation forms inside the camera lens, let it evaporate before using
the probe again.
• Do not try to disassemble any part of the probe. Doing so creates an
electrical hazard, could damage the probe, and voids the limited warranty.
• Remove the batteries if you expect to store or not use the DCS800 for an
extended period of time (months).
24
DCS800-manual_fiNAL-030313_awb 3/1/13 12:37 PM Page 24