Fairbanks FB3000 II Operators Manual - Manual (Page 58)

02/10 58 51220 Rev. 1
Appendix IV: Network Command Functions
Command Structure:
[Sender],[COMMAND],Command,[End][LF]
Where Sender is:
The Computer Name of the PC which is sending the command.
Where Command is:
Lowercase z = Zeroes all scales.
Uppercase Z1, Z2, etc = Zero a specific scale.
Uppercase ZA or ZB = Zero Group ScaleA (1 to 4) or Group ScaleB (5 to 8).
Uppercase Txxxxx = Apply Tare xxxxx to Active scale where xxxxx = Tare value.
Uppercase T#,xxxxx = Apply Tare xxxxx to Selected scale # where xxxxx = Tare value
and # = Scale number.
Uppercase A = Auto Tare Active scale
Lowercase u = Change units on all scales.
Uppercase U1, U2, etc. = Change units on a specific scale.
Uppercase UA or UB = Change units on Group ScaleA (1 to 4) or Group ScaleB (5 to 8).
Uppercase S# = Make Scale # (1-8) the Active scale where # = Scale number.
Poll Character (see Configured Output) sends configured output.
LF = Line Feed
Example:
[Freds PC],[COMMAND],Z1,[End][LF]
i.e. – Freds PC is requesting Scale 1 to Zero.