beautypg.com

Replacing the scale platform wheels, Load cell replacement, continued, Crimp connectors – Fairbanks Aegis Transport Scale User Manual

Page 23: End cover, Wheel, Three-quarter inch (¾”) open-ended wrenches

background image

Section 3: Service & Maintenance

04/10

23 51191 Rev. 2

3.2.4. Load Cell Replacement, Continued

13. Strip away all the insulation from the four (4) Load Cell to a minimum of ¾”.

14. Using

Crimp Connectors

, fasten all five

(5) green wires together, all five (5) black
wires together, all five (5) white wires
together, all five (5) red wires together, and all
five (5) yellow wires together.

15. Replace the Junction Box Cover (for Stainless

Steel Scales), then the Platform Back Cover.

16. Place scale upright and find a level location to calibrate the scale.

─ If the scale rocks in the frame, adjust one of the front load cell feet to correct it.

17. Reapply power to the Instrument.

18. Recalibrate the scale with the Instrument Service Manual.

19. Test the Platform for proper operations.

3.2.5. Replacing the Scale Platform Wheels

NOTE:

It is not necessary to remove the

End Cover

for servicing a defective

Wheel,

but it may be easier.

1. Using two (2)

three-quarter inch (¾”) Open-ended Wrenches

, remove

the Nut from the Axle Bolt, then discard the defective Wheel.

2. Replace the Wheel.

3. Screw the Axle Bolt to the Nut.

4. Place the Scale upright, then put it where it

best suits the user needs.
─ If the scale rocks in the frame, adjust one of

the front load cell feet to correct it.

.

WIRE COLOR

Red

(

−) Signal

White

(+) Signal

Black

(

−) Excitation

Green

(+) Excitation

Yellow

Ground