Fairbanks Aegis Transport Scale - Manual (Page 11)

Section 1: General Information
04/10 11 51191 Rev. 2
1.2.1. Service Technician’s Responsibilities
 All electronic and mechanical calibrations and/or adjustments required for making
this equipment perform to accuracy and operational specifications are considered
to be part of the installation.
─ They are included in the installation charge.
─ Only those charges which are incurred as a result of the equipment's inability to
be adjusted or calibrated to performance specifications may be charged to
warranty.
 If the equipment consists of printed circuit assemblies, they must be handled
using ESD handling procedures, and must be replaced as units.
─ Replacement of individual components is not permitted.
─ The assemblies must be properly packaged in ESD protective material and
returned intact for replacement credit per normal procedures.
 All electrical assemblies must be replaced as assemblies or units.
─ Replacement of individual components is not permitted.
─ These components must be returned intact for replacement credit using the
standard procedures.
 All electronic and mechanical adjustments are considered to be part of the
installation, and are included in the installation charge(s).
─ Included is any required computer programming or upgrades.
─ Included are any accuracy and/or operational specification changes.
 Only those charges which are incurred as a result of the equipment's
inability to be adjusted to performance specifications may be charged to
warranty.
 The AC receptacle/outlet shall be located near the Indicator and easily accessible.
 Electrical connections other than those specified may not be performed.
 No physical alterations (mounting holes, etc.) are permitted during installation.
1.2.2. Users’ Responsibility
 Absolutely no physical, electrical or
program modifications other than
selection of standard options and
accessories are to be made to this
equipment.