Fairbanks Aegis Transport Scale - Manual (Page 18)

Section 3: Service & Maintenance
04/10 18 51191 Rev. 2
3.2.1. Disassembling the Platform
1. Cycle-down the power to the indicator, then unplug the unit, if applicable.
2. Lay down the Scale on its back.
3. At the Wheel-base End of the Platform,
remove the four (4) Fastening Bolts of
the Cover using the
seven-sixteenths
inch (7/16”) Open-ended Wrench .
4. Using a half inch ( ½”) Open-ended
Wrench , unscrew the four (4) Bolts on
each corner of the Platform until each is
past the Load Cell Rubber Foot.
5. Carefully pull up, then out the top edge of
the Scale Platform, and lay it down on the
Pillar.
 Be careful not to pinch fingers.
─ Doing this will expose where the Cables
meet at the base of the Indicator Pillar,
and also the Load Cell Connections in
each corner.
6. Check the Interface Cable from the
Platform to the Instrument for visible
breaks or cracks.
─ While laying down the Platform, pull
out some slack of the wires from the
hole to the Pillar.
C A U T I O N
ALWAYS remove power from the Instrument before servicing.