Fairbanks Aegis Transport Scale - Manual (Page 20)

Section 3: Service & Maintenance
04/10 20 51191 Rev. 2
3.2.2. Pillar Replacement Steps,
Continued
7. Use two 9/16” Open-ended Wrenches
on the 3/8” x 3-1/2” Bolts through the Pillar
and on the Fastening
Nuts.
8. Remove the (2) ¼” x .50” Bolts using a
7/16” Open-ended Wrench to loosen the
pillar from the base.
9. Carefully push the Indicator Cable through the
top Access Hole, pulling the old Pillar away
from the base carefully, tugging the cable
gently if it hangs up so not to damage it.
10. Carefully push the Indicator Cable up through
the new Pillar, and then out through the top
Access Hole.
−
Allow extra slack on the cable.
11. Insert the new Pillar into its hole on the Base, pulling the cable firmly at the top to
remove the slack.
12. Fasten the new Pillar Unit to the Base with the Nuts and Bolts.
13. Rewire the cable to the Indicator.