beautypg.com

Assembling the pillar – Fairbanks Aegis Transport Scale User Manual

Page 13

background image

Section 2: User Operations

04/10

13 51191 Rev. 2

2.1.2. Assembling the Pillar

5. At the Wheel-base side of the

Platform, remove the four (4)
Fastening Bolts of the Cover
using
the

seven-sixteenths inch

(

7/16”) Open-ended Wrench

.

6. Pull out and unwrap the cables, set

the instructional CD aside, then open
the bag of assembly hardware.

7. Using the pre-assembled Pull-string, carefully draw the Indicator Cable up

through the Pillar, and then out through the top Access Hole.

Allow extra slack on the cable.

8. Insert the Pillar into its collar on the Base.

9. Pull the cable firmly at the top to remove the slack.

10. Install the rubber boot over the load cell

cable and into the cable exit hole.

11. Use two

Open-ended Wrenches.

A

9/16”

on the 3/8” x 3-1/2” Bolts

through the Pillar and on the
Fastening

Nuts.

12. Tighten the (2) ¼” x .50” Bolts using a

7/16” Open-ended Wriench

to

secure the pillar to the base.

13. Wrap up excess Load Cell Cable and

secure in the compartment at the base
of the pillar.

14. Reinstall the Cover on the Platform with

the six (6) Fastening Bolts.

15. Wire the cable to the Indicator.