Direct Lift PP9 Plus - Manual (Page 16)

16
CAUTION NOTE !!
LUBRICATE ALL CABLE SHEAVES, BEARINGS, AND SHAFTS WITH GREASE PRIOR TO OPERATING THE LIFT.
LUBRICATE ALL ON AN ANNUAL BASIS.
Motors and all electrical components are not sealed against the weather and moisture. Install this lift in a pro-
tected indoor location. Failure by the owner to provide the recommended shelter could result in unsatisfactory
lift performance, property damage, or personal injury.
Read and heed all WARNING, CAUTION and SAFETY INSTRUCTION labels on lift.
PREVENTIVE MAINTENANCE SCHEDULE
The periodic Preventive Maintenance Schedule given is the suggested minimum requirements and minimum
intervals; accumulated hours or monthly period, which ever comes sooner.
Periodic maintenance is to be performed on a daily, weekly, and yearly basis as given in the following para-
graphs.
In the event you need replacement parts, use only Direct Lift replacement parts available from your local Direct
Lift distributor.
Do not modify the lift in any manner without the prior written consent of the manufacturer.
WARNING!!
Occupational Safety and Health Administration (OSHA) and the American National Standards Institute (ANSI)
requires users to inspect lifting equipment at the start of every shift. These and other periodic inspections are
the responsibility of the user.
Failure to perform the daily pre-operational check can result in expensive property damage, lost production time,
serious personal injury, and even death. The safety latch system must be checked and working properly before
the lift is put to use.
Failure to heed this warning can result in death or serious injury, or damage to equipment. If you hear a noise not
associated with normal lift operation, or, if there is any indications of impending lift failure - CEASE OPERATION
IMMEDIATELY! - Inspect, correct and/or replace parts as required. Use only Direct Lift replacement parts avail-
able from your local Direct Lift distributor.
Daily Pre-Operation Check (8-Hours)
• Check safety lock audibly and visually while in operation
• Check safety latches for free movement and full engagement with rack.
• Check hydraulic connections, and hoses for leakage.
• Check cables connections bends, cracks-and for loose fittings.