Direct Lift PP9 Plus - Manual (Page 11)

11
4. Drill the hole to depth equal to the length of anchor. Note: Drilling thru concrete (recommended) will al
low the anchor to be driven thru the bottom of foundation if the threads are damaged or if the lift
will need to be relocated.
5. For better holding power blow dust from the hole.
6. Place a flat washer and hex nut over threaded end of anchor, leaving approximately ½ inch of thread
exposed carefully tap anchor. Do not damage threads. Tap anchor into the concrete until nut and
flat washer are against base plate. Do not use an impact wrench to tighten! Tighten the
nut, two or three turns on average concrete (28-day cure). If the concrete is very hard only one or
two turns may be required. Check each anchor bolt with torque wrench set to 85 foot pounds.
OPERATION INSTRUCTIONS
NOTE: ALWAYS CHOCK WHEELS AND SET PARKING BRAKE BEFORE LIFTING VEHICLE!
Only authorized personnel are to operate lift. Read Operating and safety procedures Manual completely before
operating lift.
• Properly maintain and inspect lift in accordance to owner' manual.
• Do not operate a lift that is damaged or in need of repair.
• Allow only authorized personnel in the lift bay.
• Stay clear of lift when raising or lowering (no riders).
• Keep hands and feet away from pinch points at all times.
• Never override the lift operating and safety controls.
• If a vehicle is suspected of falling, clear area immediately.
• Do not rock vehicle while positioned on lift.
• Always use safety jack stands when removing or installing heavy components.
Vehicle Loading:
• Position vehicle on lift runways by having another person guide you onto the runways. Check for proper
weight distribution (center of gravity should be evenly distributed between columns).
• Set vehicle parking brake and chock tires to prevent vehicle movement.
• Use caution before lifting pickup trucks, suv's and other vehicles. The individual axle weight capacity
should not exceed 1/2 of lift capacity.
• Make sure vehicle is neither front nor rear heavy.
Raising Lift:
• Push up switch to raise lift until platform runways clear floor.
• Stop and check for vehicle movement and vehicle weight distribution. If secure raise to desired height.
• Always lower the lift to the nearest lock position by pressing the lower lever to relieve the hydraulic pres
sure and let the latch set tight in a lock position.
• Never work under a lift that is not in the locked position.
Lowering Lift:
• Clear all obstacles from under lift and vehicle, and ensure only lift operator is in the lift area.
• Stay clear of lift and raise the lift off the safety locks.