Teledyne 3010MB - Split architecture paramagnetic oxygen analyzer - Manual (Page 37)

Percent Paramagnetic Oxygen Analyzer Part I: Control Unit
Part I: 4-7
Teledyne Analytical Instruments
is in effect, pressing the ENTER button will enter the default
TETAI pass-
word for you.
Press System to enter the System mode.
TRAK/HLD Auto—Cal
PSWD Logout More
Use the < > arrow keys to scroll the blinking over to
PSWD
, and press
Enter to select the password function. Either the default
TBEAI password or
AAAAA place holders for an existing password will appear on screen
depending on whether or not a password has been previously installed.
T E T A I
Enter PWD
or
A A A A A
Enter PWD
The screen prompts you to enter the current password. If you are not
using password protection, press Enter to accept
TETAI as the default
password. If a password has been previously installed, enter the password
using the < > arrow keys to scroll back and forth between letters, and the
∆∆∆∆∆∇
arrow keys to change the letters to the proper password. Press Enter to enter
the password.
If the password is accepted, the screen will indicate that the password
restrictions have been removed and you have clearance to proceed.
PSWD Restrictions
Removed
In a few seconds, you will be given the opportunity to change this
password or keep it and go on.
Change Password?
=Yes =No
Press Escape to move on, or proceed as in Changing the Password,
below.
4.3.3.2 Installing or Changing the Password
If you want to install a password, or change an existing password,
proceed as above in Entering the Password. When you are given the oppor-
tunity to change the password:
Change Password?
=Yes =No