Teledyne 3000TA - General purpose trace oxygen analyzer - Manual (Page 24)

3 Installation Model 3000TA
3-2 Teledyne Analytical Instruments
Figure 3-1: Front Panel of the Model 3000TA
All operator controls are mounted on the control panel, which is hinged
on the left edge and doubles as the door that provides access to the sensor
and cell block inside the instrument. The door is spring loaded and will
swing open when the button in the center of the latch (upper right corner) is
pressed all the way in with a narrow gauge tool (less than 0.18 inch wide),
such as a small hex wrench or screwdriver Allow clearance for the door to
open in a 90-degree arc of radius 7.125 inches. See Figure 3-2.
Figure 3-2: Required Front Door Clearance
3.3 Rear Panel Connections
Figure 3-3 shows the Model 3000TA rear panel. There are ports for gas
inlet and outlet, power, communication, and both digital and analog concen-
tration output. The Zero In and Span In ports are not included on the stan-
dard model, but are available as options.
10"
6.7"