Teledyne 306WA - Analog trace oxygen analyzer User Manual
Page 39
A-1
T
T
T
T
Trace Oxyg
race Oxyg
race Oxyg
race Oxyg
race Oxygen Anal
en Anal
en Anal
en Anal
en Analyz
yz
yz
yz
yzer
er
er
er
er
Appendix
Appendix
Appendix
Appendix
Appendix
TELEDYNE ELECTRONIC TECHNOLOGIES
Analytical Instruments
Appendix
Appendix
Appendix
Appendix
Appendix
Specifications
Specifications
Specifications
Specifications
Specifications
Ranges:
Ranges:
Ranges:
Ranges:
Ranges:
0-1, 0-10, 0-100 ppm (optional high
range to 1000 ppm, optional low range
to 500 ppb).
Sensitivity:
Sensitivity:
Sensitivity:
Sensitivity:
Sensitivity:
0.5% of Full Scale.
Accuracy:
Accuracy:
Accuracy:
Accuracy:
Accuracy:
+2% of Full Scale at constant tempera-
ture and pressure (temperature and
pressure of calibration {for ranges 10
ppm and above}). For ranges 1 ppm
and below, Instrument Accuracy must
take into account Sensor Offset Error
which has been experimentally deter-
mined to be 30 ppb.
+5% of Full Scale over operating
temperature (once temperature equi-
librium has been achieved)
Response Time:
Response Time:
Response Time:
Response Time:
Response Time:
90% in less than 1 minute (for changes
in the lowest range).
System Operating Temperature:
System Operating Temperature:
System Operating Temperature:
System Operating Temperature:
System Operating Temperature:
5 °C to 50 °C.
Sensor Type:
Sensor Type:
Sensor Type:
Sensor Type:
Sensor Type:
Electrochemical "Flower Cell".
Signal Output:
Signal Output:
Signal Output:
Signal Output:
Signal Output:
0-1V DC (4-20mA DC optional)
Sample Requirement:
Sample Requirement:
Sample Requirement:
Sample Requirement:
Sample Requirement:
Flow: 150 cc/min (Specified flow
rate is required only during calibra-
tion).
Pressure:
1 to 150 psig.
Temperature: 15 °C to 38 °C
Power Requirement:
Power Requirement:
Power Requirement:
Power Requirement:
Power Requirement:
115 VAC, 50/60 Hz (220 optional)
Alarm Output:
Alarm Output:
Alarm Output:
Alarm Output:
Alarm Output:
2 alarms optional.
Calibrator:
Calibrator:
Calibrator:
Calibrator:
Calibrator:
Electrolytic Faradic Calibrator.