ADC 400F - Manual (Page 65)

Chapter 8: Maintenance and Troubleshooting
Megabit Modem 400F User Manual 57
Using the RS-232 Management Port
Use the RS-232 management port only when you must manually change the IP address and
subnet mask. Also, use the port if you do not remember the administrative IP address you
entered on your modem.
1 Connect the modem to a PC as shown below.
2 Configure these communication settings (if using terminal emulation, select ANSI):
• 9600 baud
• no parity
• 8 data bits
• stop bit
• flow control off
DS L
PO W ER
10BASE-T
RS232
M GMT
MDI
M
DI-X
RS-232 MGMT port
Megabit Modem 400F
Network device